Pedal...

A bit of a slow couple of weeks as far as preparing for the AFN conversion goes, but Ive done a little more trimming back of the loom, and tied some more wires up.
I discovered that the wiring diagram I had was actually wrong and a few wires didnt match the wiring to the ECU.

Sourced a usable pedal from a LHD Sharan on German Ebay, pics below with comparison to RHD pedal.
This should allow me to use the complete pedal, keep it inside the T3 and still have it in a nice position under the foot.

Top pic shows the approx position, the other 2 show the LHD pedal compared the the RHD.
The RHD would need mounting too far over to the left so wouldnt be on the flat area, although I'm sure the pedal arm could be modified